I only have two complete front bumper assemblies, and neither one is in very good shape. Both have been hit on the passenger side, bending the main full length support beam. After a few hours and bleeding knuckles, both bumper assemblies were blown apart so I could clean up the best pieces. I put the best of the two support beams and put it in my vice, got a long straight-edge and was able to straighten it out good enough. It has some ripples in a few spots, but all the mounting holes line back up to where they belong, so I think it should be fine. Since this thing is too big to fit in my blast cabinet, I took it to Master Blasters in Spokane to be media blasted.
